panel: the longer, wider and thicker the panel, the greater the prestress, the more uncontrollable it is. As contracted, many table, tea table surface are single panel, which largely enhance the probability of cracking and deformation, if is the traditional five plate combination, although leave a ring shrinkage joint, but the structure stability is too much, if it is a composite material or the furniture that stick a skin, also don't have to think too much, people want wood, is contracted, is don't structure, problems will be directly exposed. There are not many ways to solve the problem. Generally, thick panels (over 40 mm thick) require a dovetail piercing process at the back.

This type of office Partition is somewhat similar to the portable partition. It gives you full enclosure such as the floor-to-ceiling partition. You can open the partition in a number of ways.

If the panel is connected to the wooden frame below, a certain amount of room must be reserved (that is, with the direction of the wood fiber cross), otherwise the board will be stretched when the wood shrinks. In order to prevent the warping of the hunchback, the overlength panel is generally controlled within 180 cm. If possible, try to save the middle part of the panel. The overall effect will not be affected.

Aberdeen Angus - a well-known Angus bred in Ireland and grass-fed. With the integration of traditional pasture farming and advanced technology, the cattles are fed to be of high quality and more tender.


Frames: the frames themselves are the pillars of the furniture, which make the panels light and durable as they are the main structure under stress. If the panel is thick enough, it can be used directly as a frame, which is the so-called solid wood panel furniture. The problems of the frame are generally less, some of which are debonding, most of which are the shallow grooves left when the plate is installed, which do not leave the expansion of the core board, and will directly open the mortise of the frame or other connection structure. This problem has come up many times in our furniture. Another problem is because of the problem that place puts, for instance the dead weight of chest is very big, ground is uneven must look good flat, otherwise time is long, dead weight can bring about integral frame deformation, although won't damage badly (lumber is bouncy), but affect open door and drawer to pull pull.

Check out our premium Hong Kong. GDH Hotel Hong Kong offers top-class accomodation in Kowloon with easy access to MTR station. Offers various quality rooms at special rates. Make your reservation now!


Door plank: because the door plank is upright, do not face the problem such as the desktop such as water, sundry, etc., because do not have force to control, so had better be 5 in one assemble board mortise structure, colloquial say is the door (or big drawer panel) is combined by 5 lumber and become. In this way, the force component can be guaranteed, and the deformation will be minimized. I like the simple five-in-one, which is rather low key. The single-panel door is favored by simplicity, but it has structural problems. Since the hinge is usually only connected with other structures, it is easier to be distorted. It needs to strengthen the cheng process to increase stability .